Deep laser engraving of tool insert
The end product is created using a three part molding process, each requiring different information to be included in the product molding. The information required on the product surface is laser engraved into the surface of the tool insert to a depth of 0.05 – 0.1 mm. The image is inverted so that when moulded, the data comes out the correct way. The image consists of a combination of graphical image and standard text. All the data is set up within the job file and processed at the same time.
The laser used is a flash lamp Nd:YAG which can change its mode structure. With deep engraving of this nature we run the unit in TEM00. This provides the smallest beam size available providing fine detail where required. While the energy levels are low and multiple skims are required, the end result is better, as well as with minimum raisers affecting the mark itself.
If you would like further information on this application, or any other application, please request a call back or, talk to one of our laser marking specialists by going to our contact page – link below.
Contact Us for Laser Engraving, Marking & Cutting Advice (thinklaser.theprogressteam.com/)
