Laser Engraving of Wood near Redhill

In this case study we visit our jobshop department. For this visit we are going to focus on the laser engraving of wood and what creations have been made in our jobshop as part of their continuing development of tips, tricks and best practices for laser engraving of wood.

In this visit we demonstrate the detail that can be laser engraved onto specific wood products for images such as maps of cities for example. In the below pictures the laser equipment that was used was our very 1400 x 900 Lightblade machine.

Even on such a large section of wood, you can see the both the required detail and the inevitable issue that many customer face with laser engraving of wood, and that is the very thing that gives wood in inherent beauty. The laser being a consistent engineering tool meeting the natural deviation of wood, causes the differing tones on the laser engraving. This can be used to create a unique laser engraving as unique as the last laser engraving.

For a more indepth look at our recommendations of Laser engraving of wood, you can visit our news page How to Engrave Wood with a Laser

For these components being lasered, unless it is part of a continuous run of similar product then no jigg is really required. The machine can be setup to run the laser whenever you position the laser head or by using the absolute coordinate system.

If you would like further information on our Laser Engraving of Wood near Redhill capabilities or anywhere else in the country. Please either visit our Case Studies page, request a call back or talk to one of our laser marking specialists by going to our contact page – link below.

Contact Us for Laser Engraving, Marking & Cutting Advice (thinklaser.theprogressteam.com/)