Laser Marking Near Sunbury on Anodised Aluminium – Think Automotive

In this case study we visit our customer Think Automotive. We currently do laser marking on their range of Anodised Aluminium car parts. The range consists of a range of shapes and sizes of oil cooling system connectors and cover plates. The information that is marked on the product is for product branding.

Laser marking anodised aluminium is done on our inhouse flash lamp Nd:YAG laser system with a f-180 F-theta lens, the marking process of these particular components takes approximately between 10 and 40 seconds. The product is laser marked with two passes, the first is to remove the anodising from the product and the second is a clean up pass, which restores the edge quality and makes the surface of the mark more uniform.

For these parts a corner jigg is used to locate the part accurately from component to component. On these components there is a requirement for a toleranced mark on the product. So the use of this jig is ideal as it has the required two end stops for both X and Y axis. For better tolerances or more detailed parts, separate bespoke jig can be made and used by ourselves.

These components are all used in the specialist supply of oil cooling systems and all aspects of a cars plumbing system. For more information on what type of oil cooling systems please visit Think Automotive – bespoke automotive plumbing.

If you would like further information on our Laser Marking near Sunbury capabilities or anywhere else in the country. Please either visit our Case Studies page, request a call back or talk to one of our laser marking specialists by going to our contact page – link below.

Contact Us for Laser Engraving, Marking & Cutting Advice (thinklaser.theprogressteam.com/)